Using a flat mop to clean the floor is a simple process that can help you effectively clean the floor.
Prepare the mop:
Before use, make sure the flat mop head is clean.
Install a clean mop pad onto the flat mop head.
Prepare the cleaning solution:
Depending on the type of floor to be cleaned, add an appropriate amount of water and cleaning solution to the bucket.
Wet the mop pad:
Place the mop pad into the cleaning solution bucket and wring out excess moisture. The mop pad should remain damp but not dripping wet.
Start mopping:
Begin at one corner of the room and clean the entire floor in sections.
Use back-and-forth or “8” shaped motions to mop, slightly overlapping each pass to ensure full coverage.
Pay special attention to areas with spills, stains, or heavy buildup of dirt.
Rinse and wring out the mop:
Regularly rinse the mop pad in the cleaning solution to remove dirt and hair.
Wring out the mop pad as needed to ensure it remains damp but not dripping wet.
Replace the mop pad as needed:
If the mop pad becomes excessively dirty during mopping, replace it with a clean one to prevent spreading dirt to other areas.
Complete mopping:
After finishing mopping, rinse the mop pad one last time and mop again to ensure all areas are clean.
Allow the floor to air dry naturally, or use a dry mop pad to accelerate the drying process if needed.
Clean and store the mop:
After mopping, thoroughly rinse the mop pad, let it dry completely, and store it properly.
Clean and disinfect the flat mop head according to the manufacturer's instructions to maintain hygiene.
By following these steps, you can effectively clean the floor with a flat mop and achieve a clean, shiny surface. Regular maintenance and proper care of the mop will help ensure the durability and cleaning effectiveness of the cleaning tool.
